Installing The Hard Drive Into Hard Drive Carrier; Figure 6 Removing Hard Drive - Quantum NDX Series User Manual

Installing the Hard
Drive into Hard Drive
Carrier

Figure 6 Removing Hard Drive

Quantum NDX NAS Tower User's Guide
1 Remove the two screws securing the hard drive to the drive carrier
and remove the hard drive. Place the hard drive carrier on a flat
surface such as a desk, table or work bench.
4
Drive Carrier
2 Slide the hard drive into the carrier with the printed circuit board
side facing 2. down.
3 Carefully align the mounting holes in both the drive carrier and the
hard drive.3.
4 Secure the hard drive to the carrier using six screws.
5 Replace the drive carrier into the chassis. Make sure to close the
drive carrier handle to lock the drive carrier into place.
Chapter 4: Chassis Setup and Maintenance
Hard Drive
Replacing a Hard Drive
4
19