Installing The Ndx 1U Nas Server Into A Telco Rack - Quantum NDX Series Installation Manual

NDX NAS 1U Rack Installation Guide
Installing the NDX 1U
NAS Server into a Telco
Rack
Figure 10 Installing Server into
Telco Rack
12
To install the NDX 1U NAS SERVER into a Telco (post style) rack, use two L-shaped
brackets on either side of the NDX 1U NAS server (four total).
1 Determine how far the NDX 1U NAS server will extend out the front of the rack. The
NDX 1U NAS server should be positioned to balance the weight between front and
back.
2 Attach the two front brackets to each side of the NDX 1U NAS server, then position
the two rear brackets with just enough space to accommodate the width of the
Telco rack.
3 Finish by sliding the NDX 1U NAS server into the rack and tightening the brackets to
the rack.
Rack Installation