Preparing for Setup........2 Precautions..........2 Rail Kit Contents........3 Rack Installation ........2 Rack Mounting Instructions ....7 Quantum NDX NAS 1U Rack Identifying the Sections of the Rack Rails ............7 Installation Guide Installing the Inner Rails on the NDX 1U NAS Server ........8...
NDX NAS 1U Rack Installation Guide Preparing for Setup The rail kit (CSE-PT52L) ships in a box that should include the following: • Two sets of rail assemblies • Six rail mounting brackets • Mounting screws—needed to install the system into most standard racks Note: To install the rails, you will need a Phillips screwdriver.
NDX NAS 1U Rack • Always keep the rack's front door and all panels and components closed when not servicing to maintain proper cooling. • Disconnect all power cords before servicing. Rail Kit Contents The following pictures depict the contents of the rail kit, including rails, screws, brackets, and nuts.
NDX NAS 1U Rack Rack Installation Rack Mounting This section provides information on installing the NDX NAS 1U server into a rack with Instructions the CSE-PT52L rail kit. There are a variety of rack units on the market, which may mean the assembly procedure will differ slightly.
NDX NAS 1U Rack Installation Guide Installing the Inner Rails 1 Place one of the inner rails on one side of the NDX 1U NAS server aligning the hooks on the NDX 1U NAS on the side of the NDX 1U NAS server with the mounting holes in the rail. Make sure the inner rail faces outward, as illustrated.
Page 9
NDX NAS 1U Rack Figure 7 Outer Rail Installation Table 1 Type of Rail Nuts Rack Installation...
NDX NAS 1U Rack Installing the NDX 1U 1 Confirm that inner rails have been secured to the NDX 1U NAS server. NAS Server into a Rack 2 Confirm that the outer rails are installed on the rack. 3 Align the ends of the inner rails on the NDX 1U NAS SERVER with the front of the outer rails on the rack.
NDX NAS 1U Rack Installation Guide Installing the NDX 1U To install the NDX 1U NAS SERVER into a Telco (post style) rack, use two L-shaped NAS Server into a Telco brackets on either side of the NDX 1U NAS server (four total). Rack 1 Determine how far the NDX 1U NAS server will extend out the front of the rack.
NDX NAS 1U Rack Removing Server from In the event you need to remove the server from the rack, follow the steps below. the Rack 1 Separate the inner rail from the outer rail by depressing the black plastic flange inside the inner rail.