Receiver Led - Renishaw XM-60 multi-axis calibrator User Manual

XM multi-axis calibrator

Receiver LED

After the receiver power button has been pressed, the receiver LED will go through a start-up sequence
and after a few seconds will settle on one of the following options:
LED status
Flashing amber
Flashing purple
Flashing blue
Periodic one second amber
followed by usual operational
sequence
None
Flashing green
Flashing or solid red
Description
No roll beam detected
Launch/receiver not synchronised
and/or no roll beam detected
System is operational
Low battery
• Battery charge too low
• Battery contacts dirty/damaged
• Battery inserted incorrectly
• Receiver not operational
Wireless communication device is
not operational
Receiver not operational
Actions
• Open launch/receiver shutters
• Check launch/receiver alignment
• If issue persists, contact local Renishaw office
Run Capture while making sure launch/receiver shutters are open
No action required
Replace the battery (See Appendix A)
• Insert a fully charged battery
• If issue persists, contact local Renishaw office
• Power cycle the receiver
• If issue persists, contact local Renishaw office
• Power cycle the receiver
• If issue persists, contact local Renishaw office
41