Using The 90 Degree Bracket; Appendix B - Renishaw XM-60 multi-axis calibrator User Manual

XM multi-axis calibrator

Appendix B

Using the 90 degree bracket

The 90 degree bracket can be used in two orientations (standard and reverse).
Reverse orientation allows the launch to be mounted from the side of the machine
tool bed to maximise the length of the axis that can be measured.
Standard orientation
When using the 90 degree bracket the user must clock the side face of the
bracket to ensure it is parallel to the axis of travel (e.g. if measuring Z on a vertical
machining centre, clock one of the faces of the 90 degree bracket to the X or Y
axis of the machine).
Reverse orientation Clocking the side face of the bracket
56