Cursor Up/Dow N - Oki OKIMATE 10 Handbook

ID O P E N 3,4
ED P R I N T # 3 , C H R $ ( E R ) ;" F I N E
3D C L O S E 3
Will give you this:
FINE B O L D F I N E
CHARACTER CONTROL
C H R $ (1 4 5 )
C H R $ (1 ? )
C H R $ (1 A )
C H R $ (1 4 1 )
Cursor Up and Cursor Down Characters
OKIMATE can print both "cursor up" (upper
case letters and graphic symbols) and "cursor
down" (upper and lower case letters) charac­
ters like the ones the Commodore displays on
the screen.
GETTING BOLD
" ; C H R $ (14) ;" B O L D
Normally when you OPEN a channel to OKI­
MATE, it is set for the cursor up mode. By
adding the number " 7 " to the OPEN state­
Cursor Up
ment, you can set OKIMATE for cursor down
Cursor Down
printing fo r on e lin e only.
The statement looks like this:
Reverse On
Reverse Off
You can switch between cursor up and cursor
down by using a method like the one for wide
and fine printing, lust add CHR$(17) to print
in cursor down mode and CHR$(145) to
switch to cursor up mode.
28
" ; C H R $ (E H ) ;" F I N E "
O P E N 3 , 4 , 7