Add The Point I/O Module And Configure For Direct Connection - Allen-Bradley 1734 User Manual

Chapter 5 Configure the Adapter for Direct Connection, Rack Optimization, and Enhanced Rack Optimization in RSLogix 5000 or Logix Designer Software
72
7. Click OK to accept the configuration.
The digital input module appears indented under the local
1734-AENT/B adapter in the I/O Configuration folder.

Add the POINT I/O Module and Configure For Direct Connection

Add The Digital Sink Output Module
1. Right-click the POINT I/O Chassis in the I/O Configuration folder and
select New Module
The Select Module Type dialog opens.
2. Select the appropriate filter for Module Type Category (for the example we
selected Digital) and Module Type Vendor (for the example we selected
Allen-Bradley).
Note: to select only one category you will need to unselect those already
selected.
If you exceed the adapter chassis size trying to add more modules
IMPORTANT
than you configured, the New Module selection appears dim and is
disabled. Increase the adapter chassis size to add more I/O modules.
Rockwell Automation Publication 1734-UM018D-EN-E - September 2017
.