Install Your Adapter Module - Allen-Bradley B Series Installation Instructions Manual

Component Identification
4
5
6
7
8
9

Install Your Adapter Module

A
Mount on a DIN Rail Before Installation of the Terminal Base Units
1. Hook the lip on the rear of the adapter (A) onto the top of the
35 x 7.5 mm (1.38 x 0.30 in.) DIN rail (B).
2. Rotate the adapter module onto the rail.
3. Press the adapter down onto the DIN rail until flush.
4. DIN rail locking tab (C) will snap into position and lock the adapter to
the DIN rail.
5. If the adapter does not lock in place, use a screwdriver or similar device
to move the locking tab down while pressing the adapter flush onto the
DIN rail: releasing the locking tab to lock the adapter in place.
6. If necessary, push up on the locking tab to lock.
Rockwell Automation Publication 1794-IN082D-EN-P - January 2019
Network cable RJ45 connector (underside)
Adapter DIN rail locking tab
24V dc connections
24V common connections
Flexbus connector
IP address switches
FLEX I/O EtherNet/IP Adapters
B
1794-AENT/B
C
9