Receiving & Handling - Daikin ARQ Installation And Maintenance Manual

Figure 1: Data plate location
Receiving & Handling
This product was carefully packed and thoroughly inspected
before leaving the factory. Responsibility for its safe delivery
was assumed by the carrier upon acceptance of the shipment.
Claims for loss or damage sustained in transit must therefore
be made upon the carrier, as follows:
Visible Loss or Damage
Any external evidence of loss or damage must be noted on the
freight bill or carrier's receipt, and signed by the carrier's agent.
Failure to adequately describe such external evidence of
loss or damage may result in the carrier's refusing to honor a
damage claim. The form required to file such a claim will be
supplied by the carrier.
Concealed Loss or Damage
Concealed loss or damage means loss or damage which does
not become apparent until the product has been unpacked.
The contents may be damaged in transit due to rough handling
even though the carton may not show external damages.
When the damage is discovered upon unpacking, make a
written request for inspection by the carrier's agent within
fifteen (15) days of the delivery date. File a claim with the
carrier since such damage is the carrier's responsibility.
Storage
If equipment is stored for any length of time before installation,
it should remain in its shipping packaging in a clean, dry,
climate controlled area.
www.DaikinApplied.com
Lifting Unit
A forklift or other lifting device is needed to install this product.
Make sure lifting equipment can handle the weight of the unit
safely. Personal injury may result if improper lifting and moving
methods are used. (See Table 1 for approximate shipping weights)
Use 72" length forklift tines, short tines will damage the unit bot-
tom. Improper handling can damage internal components. Do not
stand the unit on end or stack (see Figure 2 & Figure 3)
Figure 2: Stack units maximum 2 high as shown
2 high
Correct
Figure 3: Forklift lifting requirements
5
G
eneral
WARNING
CAUTION
Lifting Points
Incorrect
D
ata
IM 1083-3