Electromechanical Unit Wiring Connections - Daikin ARQ Installation And Maintenance Manual

ElectroMechanical Unit Wiring
Connections
Electromechanical control connections are made to the
terminals located behind the left-front access panel as shown
in Figure 57. Refer to the wiring diagram (Figure 58) for wiring
details and the wiring diagram provided with the unit.
Figure 57: Thermostat control terminal connections
located in left front compartment
Figure 58: Typical electromechanical wiring diagram - Model AR, thermostat control with normally open heat, 460 volt -
3-phase
IM 1083-3
Terminal Connections for
Electromechanical Controls
CAUTION
Refer to unit wiring diagram located on inside-right front panel, for
actual wiring. Improper wiring can cause equipment and property
damage.
DANGER
Disconnect all electrical power before servicing unit to
prevent injury or death due to electrical shock.
CAUTION
Use copper conductors only. Unit terminals are not designed to
accept other types of conductors. Failure to do so may damage
the equipment.
Figure 58
Plug In
Splice
Tap Conn.
Term Conn.
Capped Wire
36
Wiring Diagram Legend
Comp Tie Point
Optional Wiring
Wired by Others
Factory Wired
Ground
www.DaikinApplied.com