End Panel Assembly - Daikin ARQ Installation And Maintenance Manual

Figure 60: Piping stub-up details, 6" end panel
Piping Stub-up Within Cabinet
Unit End Compartment
Wall Line 11½
1
Note: Space available in left end
compartment for piping stub-up.
Stub-up, including unions and shutoff
valves, must disconnect below floor
line for unit installation and removal.

End Panel Assembly

Accessory end panels are shipped separately with hardware
and kickplate.
The final step of unit installation is attaching the end panels.
End panels are required unless the unit has adjoining matching
cabinets.
1. Refer to Figure 61 for a 1" thick end panel. Attach two (2)
Tinnerman nuts to the top edge of the end panel and two (2)
to the bottom end of the unit. Align the end panel with the
front and top edges of the unit. Insert through upper mounting
holes inside unit end compartment and thread into tinnerman
clips on the end panel. Attach the end panel to the unit using
four (4) 5/32" hex socket head fasteners provided.
Figure 61: 1" end panel
21⅞" Unit
Projection
1/4"- 20 Tinnerman Nut, Clip
over Lower Hole in Unit Base
IM 1083-3
Piping Stub-up Within 6" End Panel
Unit End Compartment
1
Wall Line
10¾
Left End
Space available at left end of unit
of unit
for piping stub-up when 6" end
(Less end panel)
panel is used.
1/4"- 20 × 1/2" Screw
Tinnerman Nut,
Clip on End Panel
1/4"- 20 × 1/2"
Screw
Steel Kickplate
4
Left End of unit
(Less end panel)
2. Refer to Figure 62 for 6" thick end panel.
a. Position bracket (YC1934) on wall so angle is 5" from
end of unit and near bottom.
b. Mark and drill required hole for device to fasten bracket
to wall (not included).
c. Attach the bracket to wall.
d. Attach two (2) Tinnerman nuts to the top edge of the
end panel and one (1) to the bottom front of the end
frame.
e. Align the end panel with the front and top edges of the
unit. Attach end panel to the unit using three (3) 5/32"
hex socket head fasteners provided. Bracket should
prevent movement of panel toward the unit when pres-
sure is applied to the end panel.
Figure 62: 6" end panel with provided hardware
21⅞" Unit
Projection
1"
End
Panel
1/4"- 20 Tinnerman
Nut, Clip over Lower
Hole in Unit Corner
Bracket
38
End Panel 6"
Application and Dimension
6
All dimensions in inches
5¼" Adapter Back Painted Top (Option)
1/4"- 20 × 1/2" Screw & 1/4" Flat Washer
Tinnerman Nut,
Clip on End Panel
5"
6" End Panel
Oxford Brown Kickplate, Factory Assembled
to Base of End Panel
www.DaikinApplied.com
Angle Bracket
Welded for
Rigidity
Bracket
YC1934