Pc-Based Test Systems; Figure 3-7 Dynamometer With Dsp7001 Controller And M-Test Software; Figure 3-8 Dynamometer With 6510E Power Analyzer, Dsp7001 Controller And M-Test Software - Magtrol HD-106 User Manual

Chapter 3 – Installation/Configuration
3.3.2 PC-B
aSeD
In a PC-based motor test system, data is collected on a personal computer using Magtrol's M-TEST
Software, a DSP7000 Programmable Dynamometer Controller and requisite interface cards and
cables.
Note:
The following diagrams illustrate the required cable sets and connections for a PC-based test system
setup.
HD / ED
DYNAMOMETER
o----------
o----
o----------
PN88M070-0150 (included with dynamometer)
14 Pin/14 Pin Instrument Cable
AC/DC
Input Power
HD / ED
DYNAMOMETER
o----------
o----
o----------
PN88M070-0150 (included with dynamometer)
14 Pin/14 Pin Instrument Cable
Figure 3–8 Dynamometer with 7510 Power Analyzer, DSP7001 Controller and M-TEST Software
T S
eST ySTeMS
Magtrol's Single or Three-Phase Power Analyzer can be integrated
into this system as well as Magtrol's Temperature Testing Hardware
and Software.
DSP7001 CONTROLLER
1
2 Pin Dynamometer Brake Cable
PN88M007-0150 (included with dynamometer)
Figure 3–7 Dynamometer with DSP7001 Controller and M-TEST Software
7510 POWER ANALYZER
DSP7001 CONTROLLER
1
2 Pin Dynamometer Brake Cable
PN88M007-0150 (included with dynamometer)
Magtrol Hysteresis Dynamometers
32
PC
M-TEST
USB
PC
GPIB
M-TEST
Card
USB