Table of Contents
Advertisement
1.1
UNPACKING YOUR HYSTERESIS DYNAMOMETER
Your Hysteresis Dynamometer was packaged in reusable, shock resistant packing material that will
protect the instrument during normal handling.
1. Make sure the carton contains the following:
Hysteresis Dynamometer
14-Pin Instrument Cable
2. Inspect the contents for any evidence of damage in shipping. In the event of shipping damage,
immediately notify the carrier and Magtrol's Customer Service Department.
Note:
3. Remove the Shipping Bolt
1.
Introduction
Save all shipping cartons and packaging material for reuse when
returning the instrument for calibration or servicing.
Before proceeding any further, you will need to remove the load cell shipping/restraining
bolt if you have just unpacked a new:
HD-100
HD-106
HD-400
This does not apply to HD-800, HD-805, HD-810, HD-815, HD-825 or ED-815
Dynamometers. For further instruction see Section 3.1 Removal of the Load Cell
Shipping/Restraining Bolt.
Note:
Retain the shipping/restraining bolt for future use when
moving or shipping your Magtrol Dynamometer.
Line Cord
(not included with 700
series or HD-825)
Brake Cable
PLEASE TAKE NOTICE!
HD-500
HD-505
HD-510
8
Magtrol User Manual CD-Rom
Calibration Certificate
HD-515
HD-710
HD-700
HD-715
HD-705
ED-715
Advertisement
Table of Contents
