MAGINON IPC-1A Instruction Manual page 7

Eletrical hazard
Switch off camera if a foreign body or liquid has entered the camera. Wait until
completely dry, as there is a danger of fire and electrocution.
Switch off camera if camera has been dropped or housing is damaged, as there is a
danger of fire and electrocution.
The camera may not be dismantled, modified or repaired, as there is a danger of fire
and electrocution.
Only use the supplied power supply or a power supply with the same specification. Only
connect the power supply to a power source corresponding with the information on the
rating plate.
A power supply or output cable that is damaged may no longer be used. Replace the
power supply with same type of power supply.
Ensure that all sockets used are always accessible so that the power supply can be quickly
interrupted when required. The device can only be disconnected from the mains by
pulling out the power supply plug.
Ensure adequate ventilation and do not cover the power supply to prevent overheating.
The power supply may not be used during thunderstorms, as there is a danger of
electrocution.
Damage from heat – fire hazard
Do not leave camera in places that are susceptible to considerable increases in
temperature (e.g. inside a vehicle). The housing and internal parts may be damaged,
which in turn could cause a fire.
Do not wrap up camera or place on textiles. This could produce a build up of heat in the
camera that can cause deformation of the housing and may represent a fire hazard.
Injuries and material damage
When installing and assembling the WiFi Network Camera ensure a 3.94 inch gap on all
sides to ensure adequate ventilation. Ensure, in particular, that ventilation openings are
not covered by newspapers, table cloths or curtains.
5