Lamp Run Time - Barco R9040100 Owner's Manual

Connections
To start image projection :
a. press the 'Stand by' button once on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
When the total run time of the lamp is X-30 hours or more, the following warning message will be displayed for 1 minute. This warning
message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
Remaining

Lamp run time

20 h
When the total run time of the lamp is X hours or more, the following warning message, with the exact run time is displayed on the
screen.
WARNING
Lamp run time is X hours
Operating the lamp longer
than X hours may damage
the projector.
Please replace the lamp
<ENTER> to continue
Lamp run time is X hours. Operating the lamp longer than X hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is X hours max. Do not use it longer. Always replace with a same type of lamp. Call
a BARCO authorized service technician for lamp replacement.
Using a lamp for more than X hours is dangerous as the lamp could explode.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise the projector will restart.
Saving data, Please wait
4-2
Q…‚wrp‡‚…À‚qrÃvqvph‡v‚
T‡hqi’Ãxr’

(
STANDBY EXIT
& '
ENTER
$ %
TEXT PAUSE
"
#
SHARPN TINT BRIGHTN
!
PHASE COLOR
5976135 BARCOSIM 6 21032000
3$86( 7(;7