X8400Sc Operations; Filter Wheel; Removing An Optical Filter Holder; Installing An Optical Filter Holder - FLIR X8400sc User Manual

5 X8400sc OPERATIONS

5.1 Filter Wheel

X8400sc embeds a 4 slot filter wheel. Each slot can hold a 1-inch diameter filter with a
thickness up to 2.5mm. An identification system is also implemented so that the camera
recognizes the inserted slot and automatically adjusts the measurement configuration.

5.1.1 Removing an optical filter holder

•
Note
•
•
•
Procedure Follow the procedure to dismount a filter holder from the camera filter wheel.
Select the measurement range configuration using the filter to be used. The filter is
1
placed in front of the detector allowing access to it.
If no configuration range allows to select the correct filter, then switch off the camera
2
and manually rotate the wheel to place the filter to remove in front of the detector.
3 Gently insert the 2 pins of the filter holder tool into the corresponding holes.
4 Rotate the filter holder counter clockwise to release the holder from the wheel.
5 Gently remove the holder from the camera and store it on its case.

5.1.2 Installing an optical filter holder

•
Note
•
•
•
Procedure Follow the procedure to mount a filter holder to the camera filter wheel.
Select the measurement range configuration using the filter to be used. The
1
corresponding filter slot is placed in front of the detector allowing access to it.
If no configuration range allows to select the correct filter, then switch off the camera
2 and manually rotate the wheel to place the filter slot in which to mount the filter in front
of the detector.
Gently insert the 2 pins of the filter holder tool into the corresponding holes of the
3
holder to mount.
Place the filter holder on the location, making sure the maintaining springs threads are
in front of the corresponding holder's location.
4
Rotate the filter holder clockwise to mount the holder to the wheel until the spring
threads are correctly maintaining the holder.
User Manual X8400 sc
This operation is done close to the detector window. Pay extreme attention not
to touch or scratch the detector window. Contact FLIR service if you wish
assistance for this operation.
The detector is a very sensitive sensor. It must not be directed towards strong
visible or sun light. It is preferred to remove filters with the camera powered on
as the detector, when cooled, is less sensitive to visible light.
A filter holder tool is provided with the camera and located in the portfolio.
Do not touch the filter surface when you install the filter. If this happens, clean the
filter accordingly to the manufacturer instructions.
This operation is done close to the detector window. Pay extreme attention not
to touch or scratch the detector window. Contact FLIR service if you wish
assistance for this operation.
The detector is a very sensitive sensor. It must not be directed to strong
visible or sun light. It is preferred to remove filters with the camera powered on
as the detector, when cooled is less sensitive to visible light.
A filter holder tool is provided with the camera and located in the portfolio.
Do not touch the filter surface when you install the filter. If this happens, clean the
filter accordingly to the manufacturer instructions.
23