FLIR X8400sc User Manual page 15

4.3.2.2 Removing an infrared lens
•
Note
•
•
•
Procedure Follow the procedure to remove an infrared lens
Push forward the release button for the infrared lens (#8 on Figure 1: Camera general
1
description).
2 Rotate the infrared lens 30° counter-clockwise (l ooking at the front of the lens)
3 Carefully pull out the infrared lens from the bayonet ring
Install the protective cap or a new optic on the camera to avoid visible light to be
4
directed to the detector.
4.3.2.3 Lens identification
X8400sc lenses integrate a unique identifier. The camera reads the lens identifier and
automatically adapts the measurement ranges to the connected lens.
The lens connected to the camera is displayed in ResearchIR Max and on the LCD interface.
4.3.2.4 Adjusting the camera focus
•
Note
Camera focus can be done manually by rotating the focus ring on the lens.
•
Procedure
•
4.3.2.5 Using an Extension ring
•
Note
•
•
Extension rings can be introduced between the camera and the infrared lens in order to
change the minimum focus distance and thus the field of view of the camera. It is possible to
add several extension rings at the same time.
Please refer to the specification sheet of your infrared lens for available extension ring
dimensions and corresponding performances.
When an extension ring is used, the identification of the measurement configuration to be
used by the camera is done manually. Please refer to §4.4.4.
User Manual X8400 sc
The detector is a very sensitive sensor. It must not be directed towards strong visible
or sun light.
Do not touch the lens surface when you install the lens. If this happens, clean the
lens accordingly to the instructions in section 9.1.2 on page 52.
Lenses can be heavy. Some lenses weight several hundred grams. Be careful not to
be surprised by its weight.
When you have removed the infrared lens, put the lens caps on the lens to protect it
from dust and fingerprints.
Do not touch the lens surface when you install the lens. If this happens, clean the
lens accordingly to the instructions in section 9.1.2 on page 52.
For far focus, rotate the focus ring counterclockwise (looking at the front of the
lens)
For near focus, rotate the focus ring clockwise (looking at the front of the lens)
The detector is a very sensitive sensor. It must not be directed towards strong visible
or sun light.
Do not touch the lens surface when you install the lens. If this happens, clean the
lens accordingly to the instructions in section 9.1.2 on page 52.
Using an extension ring requires the user to have strong understanding of the
radiometric consequences and induced measurement errors. Infrared Training
Center (ITC) offers courses and training. For more information about obtaining the
training you require, contact your FLIR sales representative or ITC at
www.infraredtraining.com
15