Dynamic Range Extension "Superframing; Camera Synchronization - FLIR X8400sc User Manual

Table of Contents

6.6 Dynamic Range Extension "Superframing"

The main purpose of superframing is to capture a large dynamic range event with various

integration times. Consider a rocket launch as an example. During the launch a short

integration time would be needed to monitor the plume of the rocket. However, such a short

integration time would not yield adequate images across the rest of the rocket body. If the

integration time was increased to yield adequate images across the entire rocket, the rocket

plume would saturate the detector. Superframing cycles through up to eight different

integration periods. Below is a timing graph explaining the link between the recorded frame

and the integration time in superframing mode.

Refer to 4.4.5 to set the superframing up.

The X8400sc camera can be synchronized to an external signal. The synchronization applies

to the timing of an individual frame. The camera features a Sync IN (#4 on Figure 2) and a

Sync OUT (#5 on Figure 2) connector.

The X8400sc makes use of frame syncs to control the generation of image data. The

generation of a frame consists in two phases: integration and data readout. Depending on the

timing between these two events, you can have two basic integration modes: Integration

Then Read (ITR), and Integrate While Read (IWR). In ITR mode, integration and data

readout occur sequentially. The complete frame time is the combined total of the integration

time plus readout time. In IWR mode, the integration phase of the current frame occurs

during the readout phase of the previous frame. In other words, ITR and IWR terms refer to

whether or not the camera will overlap the data readout and integration periods. In ITR mode,

the data are not overlapped which means lower frame rates but this process provides a less

noisy image. IWR mode can enable the user to achieve much faster frame rates with a slight

increase in noise.

Upon frame sync, the camera immediately integrates followed by data read out.

•

Note

•

User Manual X8400 sc

When using an external frame sync and preset sequencing or super framing, the

external frame sync should be set to comply with ITR frame rate limits. If the external

sync rate is too fast, the camera will ignore syncs that come before the camera is

ready

Synchronization is different from triggering. The latter is described paragraph 6.8.

Figure 8 : Frame Synchronization - ITR mode

Table of Contents