Table of Contents
Advertisement
Using Top Deburring Station
1.
Open top station cover to expose abrasive
belt (see Figure 35).
Station
Cover
Figure 35. Top deburring station.
2.
Push ON/Clockwise button, then wait until
abrasive belt reaches full speed.
IMPORTANT: Make sure abrasive belt
travels towards front of machine.
3.
Stand to side of machine and position
workpiece at a slight angle to abrasive belt,
against back stop (see Figure 35), and then
slowly make light contact with belt. Move and
rotate tube as needed to remove burrs.
4.
When finished, turn machine OFF, wait for
abrasive belt to completely stop, and close
deburring station cover.
-30-
Abrasive Belt
Back Stop
Using Rear Deburring Station
1.
Open rear station cover to expose abrasive
belt (see Figure 36).
Station
Cover
Abrasive
Belt
Rest
Figure 36. Rear deburring station.
2.
Adjust and secure workpiece rest in position
(see Figure 36).
3.
Push the ON/Counterclockwise button, then
wait until abrasive belt reaches full speed.
IMPORTANT: Make sure abrasive belt
travels towards rear of machine.
4.
Stand behind machine and position workpiece
at a slight angle to abrasive belt, against rest
(see Figure 36), and then slowly make light
contact with belt. Move and rotate tube as
needed to remove burrs.
5.
When finished, turn machine OFF, wait for
abrasive belt to completely stop, and close
deburring station cover.
Model G0767Z (Mfd. Since 11/17)
Advertisement
Table of Contents
