Grizzly G0767Z Owner's Manual page 24

To test run machine:
1. Loosen cap screw securing belt cover
and open cover to expose abrasive belt
(see Figure 19).
Figure 19. Belt cover opened.
2.
Pull belt tension lever up and toward front of
machine with one hand as you guide motor
forward with other hand (see Figure 20). This
releases abrasive belt tension.
Belt Tension
Figure 20. Releasing abrasive belt tension.
-22-
Lever
3. Remove abrasive belt.
4. Close and secure belt cover.
5. Clear all setup tools away from machine.
6.
Connect machine to power supply.
7.
Twist emergency stop button clockwise until
it pops out—this resets switch so machine
will start (see Figure 21).
Emergency
Stop Button
Figure 21. Location of emergency stop button.
8. Push ON button to start machine. A correctly
operating machine runs smoothly with little or
no vibration or rubbing noises.
9. Press emergency stop button to turn machine
OFF.
10. WITHOUT resetting the emergency stop
button, press ON button. Machine should not
start.
— If machine does start (with emergency
stop button in depressed position), im-
mediately disconnect power to machine.
The emergency stop button safety
feature is not working correctly. This safety
feature must
proceeding with regular operations. Call
Tech Support for help.
Note: To re-install abrasive belt, perform
Replacing/Tensioning Abrasive Belt procedure
on Page 24.
Model G0767Z (Mfd. Since 11/17)
work properly before