Wiring Diagram - Pcb Sensor - Macnaught MX06S Instruction Manual

WIRING DIAGRAM 1
Reed Switch
To maximise the life of the reed switch contacts, the pulse board comes equipped with a 1k8Ω current limiting resistor in series
with the reed switch as standard.
NPN Open Collector Hall Effect Sensor
The output for the hall effect sensor is NPN (current sinking, open collector). For correct operation, it is advisable to have a pull
-up resistor installed.
The hall effect sensor is equipped with a 1k8Ω pull-up resistor between signal and supply as standard.
This in-built pull-up resistor can be bypassed by moving the jumper pin to the off position if required.
A pull-up resistor of your choosing can be installed between signal and supply, provided the in-built pull-up resistor be by-
passed first.
PCB
Output types A,D,E,F,G,H
PCB with Terminal Block
PCB with Soldered Wire
Note:
Local Display is
connected to Reed 1
White
Yellow
Red
Black
Green
Screening
cable
Page 10 of 38