Selecting Wall Plugs And Screws; Installation Position; Selecting A Location; Installing The Fronius String Control 250/30 Dcd Df - Fronius 250/30 DCD DF Operating Instructions Manual

Installing the Fronius String Control 250/30 DCD DF

Installing the Fronius String Control 250/30
DCD DF
Selecting wall Different wall plugs and screws are needed to install the Fronius String Control 250/30
plugs and screws DCD DF depending on the wall surface. As a result, wall plugs and screws are not supplied
as standard with the Fronius String Control 250/30 DCD DF. The installer is responsible
for selecting the right wall plugs and screws.
Installation posi- The Fronius String Control 250/30 DCD DF can be installed in any position between the
tion horizontal and vertical.
However, the cable entries and outlets must always be positioned pointing downwards.
Selecting a loca- Take the following criteria into account when selecting the location:
tion -
-
-
-
-
Installing the
1
Fronius String
Control 250/30
DCD DF
Install only on a solid, level surface; the housing must not distort when tightened
The ambient temperature must not be less than -25 °C or more than +55 °C
IP 55 degree of protection means that the Fronius String Control 250/30 DCD DF can
be installed outside and exposed to a certain amount of moisture. However, we rec-
ommend that the device is not exposed directly to moisture.
Protect from direct sunlight and exposure to the elements
Install beneath the solar modules if possible
2
59