General Description; Operation; Setup; Preparing To Paint - Titan ADVANTAGE 1100 Owner's Manual

General Description

This airless sprayer is a precision power tool used for spraying many
types of materials. Read and follow this Owner's Manual carefully for
proper operating instructions, maintenance, and safety information.
Pressure
Control
Knob
Oil Cup
Fuse
Fluid
Section
Siphon
Tube

Operation

This equipment produces a fluid stream at extremely
high pressure. read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.

Setup

Perform the following procedure before plugging in the power cord
of an electric unit.
1. Ensure that the siphon tube/suction set and the return hose
are attached and secure.
2. Using a wrench, attach a minimum of 50' of 1/4" airless spray
hose to the outlet fitting on the sprayer. Tighten securely.
3. Attach an airless spray gun to the spray hose. Using two
wrenches (one on the gun and one on the hose), tighten
securely.
Motor
NOTE: Do not attach the tip to the spray gun yet. remove
the tip if it is already attached.
Filter
make sure all airless hoses and spray guns are
PRIME/
electrically grounded and rated at or above the
SPRAY
maximum operating pressure range of the airless
Valve
sprayer.
Outlet
4. Make sure the pressure control knob is in the OFF position in
Fitting
the black zone.
5. Fill the oil cup with approximately one tablespoon of
separating oil (P/N 314-481).
ImPOrTaNT: Never operate unit for more than ten seconds
without fluid. Operating this unit without fluid will cause
unnecessary wear to the packings.
Return
Hose
6. Make sure the electrical service is 120V, 15 amp minimum.
7. Plug the power cord into a properly grounded outlet at least
25' from the spray area.
ImPOrTaNT: always use a minimum 12 gauge, three-wire
extension cord with a grounded plug. Never remove the third
prong or use an adapter.
Preparing a New Sprayer
If this sprayer is new, it is shipped with test fluid in the fluid section
to prevent corrosion during shipment and storage. This fluid must
be cleaned out of the system thoroughly with mineral spirits before
spraying paint.
ImPOrTaNT: always keep the trigger lock on the spray gun in
the locked position while preparing the system.
1. Place the siphon tube into a container of mineral spirits that
has a flash point of 140ºF (60ºC) or above.
2. Place the return hose into a metal waste
container.
3. Move the PRIME/SPRAY valve down to the
PRIME position.
4. Turn the unit on and set the pressure to
minimum by turning the pressure control
knob to the "MIN PSI" setting in the yellow
zone.
Min. – 1800 PSI
(yellow zone)
Turbo PulseClean
(red zone)
(black zone)
5. Allow the sprayer to run for 15–30 seconds to flush the
test fluid out through the return hose and into the waste
container.
6. Turn off the sprayer by moving the pressure control knob to
the OFF position in the black zone.
4
Min.
PSI
(Bar)
Max. PSI
On/O (Bar)
OFF
Pressure Control Knob
© Titan Tool Inc. All rights reserved.
1800 – 3300 PSI
(green zone)