Replacing The Prime/Spray Valve; Replacing The Filters - Titan ADVANTAGE 1100 Owner's Manual

replacing the PrImE/SPray Valve

Perform the following procedure using PRIME/SPRAY valve
replacement kit P/N 0507690.
1. Drive the groove pin out of the valve handle.
2. Remove the valve handle and the cam base.
3. Using a wrench, loosen and remove the valve housing
assembly.
4. Make sure the gasket is in place and thread the new valve
housing assembly into the filter block. Tighten securely with a
wrench.
5. Place the cam base over the valve housing assembly.
Lubricate the cam base with grease and line up the cam with
the filter block using the dowel pin.
6. Line up the hole on the valve stem with the hole in the valve
handle.
7. Insert the groove pin into the valve handle and through the
valve stem to secure the valve handle in position.
Filter
Housing
Dowel Pin
Cam Base

replacing the Filters

Pump Filter
1. Loosen and remove the filter body
by hand.
2. Slip the filter off of the core spring.
3. Inspect the filter. Based on
inspection, clean or replace the
filter.
4. Inspect the o-ring. Based on
inspection, clean or replace the
o-ring.
5. Slide the new or cleaned filter over
the core spring with the filter spring
adapter in place. Push the filter
into the center of the filter housing.
6. Slide the filter body over the filter
and thread it into the filter housing
until secure.
NOTE: The filter housing should be
hand-tightened, but make
sure the filter housing is
seated fully into the pump
manifold.
Gasket
Valve Housing
Assembly
Valve Stem
Groove Pin
Valve Handle
Filter
Body
Filter
Spring
Filter
Adapter
Core
Spring
O-ring
Filter
Housing
Gun Filter
1. Pull the bottom of the trigger
guard forward so that it comes
loose from the handle assembly.
2. Loosen and remove the handle
assembly from the gun head.
3. Pull the old filter out of the gun
head.
4. Slide the new filter, tapered end
first, into the gun head.
5. Make sure the handle seal is in
position and thread the handle
assembly into the gun head until
secure.
6. Snap the trigger guard back onto the handle assembly.
choosing the correct Spray Gun Filter
Use the proper gun filter based on the type of material being applied
as shown below.
Part Application
Number
0089960 Synthetic resin,
enamels, clean
varnishes, stains
azures
0089959 Base coat enamels,
primer enamels,
llers, marking paints,
textured enamels
0089958 Emulsions,
latex paints,
acrylic paints
0089957 Heavy bodied latex,
block llers,
elastometrics
NOTE: For more detail, part number information, and an
assembly drawing, please see the G-10 airless Spray
Gun Owner's manual (P/N 0286928).
8
Gun
Housing
Filter
Handle
Seal
Handle
Filter Color of
Type Filter
Body
Extra ne red
Fine yellow
Medium white
Coarse green
© Titan Tool Inc. All rights reserved.