Installing The Batteries In The Digital Transmitter And The Computer; First Install The Battery In The Digital Transmitter - VDO Cyclecomputing C1DS Instruction Manual

GB

2.1 Installing the batteries in the digital transmitter and the computer

Both, your VDO computer and your VDO transmitter are coming with a 3 V battery (type
C1DS
C2DS
2032).
C3DS
C4DS
A. First install the battery in the digital transmitter
Step 1. Place the battery into the transmitter housing, +pole face-up.
Step 2. Make sure the battery is not edged over.
Step 3. Check if the rubber washer is flatly positioned on the battery door.
Step 4. Place the battery door on the compartment, take a coin and twist it to the right until
detent (approx. 1/3 turn).
B. Install the battery in the computer immediatly after the installation of the battery
in the transmitter.
At the initial putting into operation, the computer is automatically trying to find the transmitter.
By this, the computer also learns the transmitters coding
62
>>> P02