Advertisement
Installation Instructions
Mounting the Drive Modules
1.
Install the mounting backplate to the cabinet rails, making sure that the pem studs/nuts face the back of the enclosure.
Install both exhaust vent gaskets (3) to the back side of the drive module. Refer to Illustration 1.5.
2.
3.
Align the slot gasket (2) with the lower mounting holes in the drive module and install the gasket onto the drive module.
See Illustration 1.6.
4.
Assemble the 2 base mounting plates by attaching the gasket (4) onto the base mounting plate (5). Refer to
Illustration 1.6.
5.
Insert an M10 screw through the base mounting plate/gasket assembly and loosely fasten into the mounting backplate.
Perform this step again for the other base mounting plate/gasket assembly. Make sure that the screws are secure since
the base of the drive module rests on these screws.
6.
Slightly lean the top of the drive module forward and set the cutouts in the base of the module onto the lower 2 M10
screws in the mounting backplate.
7.
Slowly push the top of the drive module back against the mounting backplate until the top 2 holes on the module line
up with the 2 mounting holes in the mounting backplate. Secure the top of the drive module using 2 M10 screws (4) and
torque to 19 N · m (170 in-lb). See Illustration 1.5.
8.
Torque the M10 screws securing the base of the module to 19 N · m (170 in-lb).
Install the top plate assembly. Refer to Illustration 1.10.
9.
9a
Place the gasket (8) over the grill opening on the top of the unit.
9b
Place the top plate (2) over the gasket. Secure it with the 11 M5x12 screws included in the kit.
Torque to 5.1 N · m (45 in-lb).
10.
Install the next drive module to the mounting backplate.
6
In-bottom/Out-back Cooling Kit for VLT®
Parallel Drive Modules
VLT® Series FC 102, FC 202, and FC 302
Danfoss A/S © 04/2016 All rights reserved.
MI92L102
Advertisement
