Advertisement
iR ADV C5500 series Advance Maintenance Guide
Procedure
Detail & Action
C12
1. Execute COPIER>FUNCTION>MISC-P>ITB-INIT.
2. See the COPIER>DISPLAY>MISC>ITB-POS.
3. Repeat 1 and 2 for 3 times.
Check the ITB
POS
Check iTB-POS & iTB-POS2
value; If not in range,
execute iTB Alignment Adj.
( See Service Manual )
C13
Check Finishing
devices
C14
1.
Settings/Registration > Adjustment/Maintenance > Adjust Image
Perform Auto Correct
Color Mismatch/Auto
Adjust Gradation /
2. Auto Adjust Gradation ( Pick Paper Type & use Full Adjust)
Auto Correct Color
Settings/Registration>Adjustment/Maintenance
Tone Setting
>Adjust Image Quality• > Auto Adjust Gradation
3.
Settings/Registration>Adjustment/Maintenance
>Adjust Image Quality• > Auto Correct Tone Settings
Check
1. If E540-8002, E542-8002,
110F, or 1104 is shown in
the error or jam list ensure
there are no boxes or waste
bin inhibiting the travel of
the trays up and down
movement.
2. Ensure all paper clips and
staples are cleaned out of
the finishing device.
Check
Auto Correct Color Mismatch
Quality• > > Auto Correct Color Mismatch
Auto Correct Color Tone Settings
Note
Point:
1. If the value of service mode is out of range,
perform the ITB Alignment Adjustment.
Note:
Since this product is not affected by the tilt
of the floor, adjustment of the adjuster height is
not valid. Therefore, if it is out of range, perform
Adjust
"ITB adjustment". ( See Service Manual)
Point:
• P oint:
1. If error message shows up when performing
Auto Correct Color Mismatch, patch
registration shutter could be broken. Check
patch registration shutter .
2. If the customer use the heavy paper,
perform Auto Adjust Gradation with plain
and heavy paper.
Adjust
3. If the machine has imagePASS P1, perform
calibration for imagePASS after performing
Auto Correct Color Mismatch/Auto Adjust
Gradation.
Time
Check
5
min
Adjust
15
min
Check
5
min
Adjust
5
min
Advertisement
