Section 6: Troubleshooting
June 2012
6.3.2
Remove Feature Assembly
The Wireless Feature Board is located in the electronics compartment. To remove the assembly,
perform the following procedure.
1.
2.
3.
4.
5.
6.
7.
Figure 6-1. Sensor module connector view
68
Remove the housing cover opposite the field terminal side.
Remove the LCD Display, if applicable. To do this, hold in the two clips and pull outward.
Loosen the two small screws located on the assembly.
Replace the LCD Display. This will help in removing the assembly.
Pull out the assembly to expose and locate the SuperModule connector and antenna
connector.
Grasp antenna connector by the base and pull upwards to disconnect.
Grasp the SuperModule connector, squeeze the clips and pull upwards
(avoid pulling wires).
Wireless Housing
Reference Manual
00809-0100-4102, Rev AA
Troubleshooting