Advertisement
Verify Switch Operation
4
1
1.
Verify basic switch operation by checking the system LEDs.
When operating normally, the PSU1/PSU2, Diag, and Fan LEDs
should all be on green.
Perform Initial System Boot
5
1.
If the network operating system (NOS) installer is located on a
network server, first connect the RJ-45 Management (Mgmt) port
to the network using 100-ohm Category 5, 5e or better twisted-
pair cable. (Not required if the NOS installer is located on
attached storage.)
2.
Boot the switch. Wait for the ONIE software to locate and
execute the NOS installer, and then wait for the installer to load
the NOS software image.
Subsequent switch boots will bypass ONIE and directly run the
NOS software.
Note:
For switches with ONIE software pre-loaded, refer to
the network operating system (NOS) installer and NOS
documentation for details on software options and set up for
ONIE.
Switch Chassis
Size (WxDxH)
438.4 x 580 x 87.7 mm (17.26 x 22.83 x 3.45 in.)
Weight
14.11 kg (31.1 lb), with two installed PSUs
Temperature
Operating: 0° C to 45° C (32° F to 113° F)
Storage: -40° C to 70° C (-40° F to 158° F)
Humidity
Operating: 5% to 95% (non-condensing)
Power
760 Watts maximum
Consumption
AC PSU
Power Rating
100–240 VAC, 50-60 Hz, 12–6 A, 850 Watts
Connect Network Cables
6
1.
For the RJ-45 Management port, connect 100-ohm Category 5,
5e or better twisted-pair cable.
2.
Connect DAC cables to the QSFP28 slots. Or first install
QSFP28 transceivers and then connect fiber optic cabling to the
transceiver ports.
The following transceivers are supported:
■
■
3.
As connections are made, check the port status LEDs to be sure
the links are valid.
Each QSFP28 port has four LEDs that indicate valid links in the
following modes:
■
■
■
■
Hardware Specifications
Regulatory Compliances
Emissions
Immunity
Safety
– 2 –
3
100GBASE-CR4, AOC, SR4, LR4, and PSM4
40GBASE-CR4, SR4, and LR4
1 LED Blue — 100 Gbps mode
1 LED Orange — 40 Gbps mode
1-4 LEDs White — 25 Gbps breakout mode (four lanes)
1-4 LEDs Green — 10 Gbps breakout mode (four lanes)
EN 55032:2015+AC:2016, Class A
EN 61000-3-2:2014, Class A
EN 61000-3-3:2013
47 CFR FCC Part 15:2015, Subpart B, Class A
CE Mark
EN 55024:2010+A1:2015
IEC 61000-4-2/3/4/5/6/8/11
UL (CSA 22.2 No 60950-1 & UL60950-1)
CB (IEC/EN60950-1)
Quick Start Guide
1
2
Advertisement
