MTU 12V2000Gx6 series Operating Instructions Manual page 154

4. Open threaded vent plug and ensure that fuel
does not emerge continuously.
Result: The filter can now be replaced!
5. If fuel emerges continuously, check shutoff
valve in fuel supply, notify Service.
Note: • As soon as the filter housing is opened,
absolute cleanness is imperative!
• Carefully extract the filter element straight
up avoiding contact with the upper edge of
the cylinder if at all possible to prevent
contamination of the fuel remaining in the
filter housing.
6. Unscrew filter cover (1) and pulll it together
with filter element (3) from filter housing (4).
7. Unclip filter element (3) from filter cover (1).
8. Install new O-ring (2) on filter cover (1).
9. Coat new O-rings on filter cover and filter ele-
ment with fuel.
10. Clip new filter element (3) into filter cover (1).
11. Screw filter cover (1) into filter housing.
Result: Filter cover (1) must lie flat on the housing
(4).
12. Tighten filter cover (1) with torque wrench to the specified tightening torque.
Name
Filter cover
13. Replace other filter elements in the same way.
14. Open fuel supply.
15. Vent fuel prefilter (→ Page 155).
16. Check fuel prefilter for leaks.
154 | Fuel Filter | MS15054/03E 2018-07
Size Type
Tightening torque
Lubricant Value/Standard
40 Nm