Installing The Tracer Adaptiview Display - Trane CVHH Installation, Operation And Maintenance Manual

Installation: Controls
Installing the Tracer AdaptiView
Display
The Tracer AdaptiView display is boxed, shrink-w rapped,
and located behind the control panel during shipm ent. The
Tracer AdaptiView display m ust be installed at the site.
Im port ant : The Tracer AdaptiView display and display
arm are to be installed by Trane, or an agent
of Trane, for best results.
1. Unw rap the control panel and display arm . Locate the
box containing the Tracer AdaptiView display behind
the control panel (labeled A).
2. After the box containing the display has been
rem oved, rem ove the shipping bracket from the back
of the control panel (B).
3. Rem ove the Tracer AdaptiView display from the box.
N ot e: Screw s are M 4 (m etric size 4), 6 to 8 m m long,
and are shipped w ith the display.
4. Plug the pow er cable (C) and the Ethernet cable (D) into
the bottom of the display.
N ot e: Both cables are already present and extend
from the end of the display arm .
D
5. Adjust the Tracer AdaptiView display support arm so
the base plate that attaches to the Tracer AdaptiView
display is horizontal.
44
A
B
C
CAUTION
Tension in Display Support Arm!
Failure to ensure that the support arm is in the full
upright position w hen removing the Tracer AdaptiView
display from the support arm could result in
unexpected movement of the spring-loaded support
arm w hich could result in personal injury.
N ot e: Review "Adjusting the Tracer AdaptiView Display
Arm , " p. 45 prior to attaching the display as som e
adjustm ents m ay be required prior to attaching the
display to the support arm base.
6. Position the Tracer AdaptiView display, w ith the LCD
screen facing up, on top of the display support arm
base plate.
N ot e: Ensure the Trane logo is positioned so that it
w ill be at the top w hen the Tracer AdaptiView
display is attached to the display support arm .
NOTICE:
Do Not Drop Display!
Failure to keep a firm grip on the Tracer AdaptiView
display as you position the display on top of the
support arm base place could result in equipment or
property-only damage.
7. Align the four holes in the display w ith the bolt holes
in the display support arm base plate.
8. Attach the Tracer AdaptiView display to the display
support arm base plate (E) using the M 4 (m etric size 4)
screw s referenced in Step 3.
E
CVHH-SVX001A-EN