Omron D6F-PH User Manual page 24

4. Enable CRC Function
1. Set to "1" to bit[1] of the CRC control register.
I2C command: Write 02h to the CRC Control Register (D049h).
ACK
START Slave Address ACK Access Address ACK Reg Address H ACK Reg Address L
S D8h (6Ch (7b)+ 0) A 00h A D0h A 49h A
Serial Ctrl ACK Write Data ACK STOP
18h A 02h A P
5. Execute Hardware Reset
1. Set to "1" to bit[7] of the Power Sequence register.
I2C command: Write 80h to the Power Sequence Register (0Dh).
START Slave Address ACK Access Address ACK Write Data ACK STOP
S D8h (6Ch (7b)+ 0) A 0Dh A 80h A P
The hardware reset after the execution, bit 7 is cleared to "0" automatically.
23
D6F-PH MEMS Differential pressure Sensor User's Manual (A288)