Advertisement

In
nstru
uctio
on M
MX440
M
030PU
Manua
al
U-XXX
X Pum
mp

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MX44030PU series and is the answer not in the manual?

Questions and answers

Summary of Contents for Binks MX44030PU series

  • Page 1 nstru uctio on M Manua MX440 030PU U-XXX X Pum...
  • Page 2 Inst truction n Manual P Page 2 of 12 Issue: 1.0...
  • Page 3: Specification

    Instruction Manual Specification Feature Unit 7.2 US Gal. /min. Flow at 60 cycles/min 26.4 Litres/min. 0.12 US Gallons Flow per cycle 0.440 Litres Recommended intermittent cycle rate 25 cycles/min 5” Pump Stroke 127 mm Ratio 30:1 3045 PSI Maximum Fluid Pressure 210 BAR Fluid Inlet 1½”...
  • Page 4 Inst truction n Manual P P age 4 of 12 Issue: 1.0...
  • Page 5 Inst truction n Manual P P age 5 of 12 Issue: 1.0...
  • Page 6 Inst truction n Manual P P age 6 of 12 Issue: 1.0...
  • Page 7: General Description

    A built in Solvent cup cleans and lubricates the pump rod and seals to prolong working life. The air motor also utilises the Binks quick exhaust technology to prevent air valve freezing conditions when high cycle speeds are employed.
  • Page 8 Inst truction n Manual = GR REASE (AG GMD-010) = LO CTITE = TO ORQUE P Page 8 of 12 Issue:...
  • Page 9 Instruction Manual Parts List – ‘MX44030PU-CMH/SMH Pump Assembly’ ITEM PART No DESCRIPTION REMARKS 104037 A260 AIR MOTOR 164838 RIVET 165100 M16 SPRING WASHER 165594 M16 x 60 SOCKET CAPSCREW 193540 LABEL 193543 COVER CLIP 193616 TIE ROD 193938 FX440 HAND GUARD 193940 FX440 GUARD ADAPTOR FX440PU-CMH...
  • Page 10: Pump Accessories

    Confirmation from the material supplier should be sought to ensure compatibility to prevent the risk of contamination. Check daily for excessive material leaks into the solvent cup A universal lubricant is available - Wet Sol ‘Plus’ Binks Part Number 863009 Page 10 of 12 Issue: 1.0...
  • Page 11: Fault Finding

    Instruction Manual Fault Finding Symptom Possible Cause Remedy Motor will not run a. No Air supply a. Check air and fluid supply ball valves and supply hoses. b. Air piston seal worn. b. Replace Piston seal c. Pilot valve assemblies c.
  • Page 12 Customer Se ervice and Technical S Support 800 -992-4657 Toll Free F Facsimile 800 0-246-5732 Binks registered offi ice Finishing Brands Germany GmbH Jus stus-von-Liebig-Straß ße 31, 63128 Dietzen nbach. Amtsgericht O O ffenbach HRB 4356 age 12 of 12 Issue:...

Table of Contents