Avalue Technology CCD-07W01 User Manual page 4


Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
 Consult the dealer or an experienced computer technician for help
Technical Support and Assistance
1.
Contact your distributor or sales representative for technical support if you need
additional assistance. Please have the following information ready before you call:

Product name and serial number

Description of your peripherals attachments

Description of your software (OS, version, application software, etc.)

A complete description of your problems

The exact wording or any error messages
Safety Instruction
Use the following safety guideline to help protect yourself and CCD.

Do not attempt to service the CCD yourself. Always follow installation instructions closely.
 Be sure that nothing rests on the AC adapter's power cable and that the cable is not located
where it can be tripped over or stepped on.
 Do not cover the AC adaptor with papers or other items that will reduce cooling; also, do not
use the AC adapter while it is inside a carrying case. Use only the AC adapter, power cord, and
batteries that are approved for use with this CCD. Use of another type of battery or AC adapter
may cause risk of fire or explosion.
 If you use an extension cable with the AC adapter, ensure that the total ampere rating of the
products plugged in to the extension cable does not exceed the ampere rating of the extension
cable.

When you move the CCD between environments with very different temperature and/or
humidity ranges, condensation may form on or within the CCD. To avoid damaging the CCD,
allow sufficient time for the moisture to evaporate before using the CCD.
 When you disconnect a cable, pull on its connector or on its strain relief loop, not on the cable
itself. As you pull out the connector, keep it evenly aligned to avoid bending any connector pins.
Also, before you connect a cable make sure both connectors are correctly oriented and aligned.
iv