5.2 Display
Real value
Remote
Probe
Hot
Remote
External
HotPlatewar
control
probe
ning
Figure 4
Characters
Display temperature when the heating function is
Temp and ℃
switched ON.
Display stirring state when the stirring function is
Stir
switched ON.
Display the setting mode in order of A, B and C
Mode
after pressing mode key.
Set
Press setting key to set function, and display Set characters.
Display hot warning if the heating plate temperature is
Hot
above 50℃ after switching OFF the heating function.
Probe
Display when using external probe.
Remote
Display in case of remote control.
Err
Display in case of error happening.
Rated value 、
Display value in case of heating or stirring function
Real value
switching ON.
Table 3
Temperature Stir
Temp
Stir
Err
Set
Set
℃
Error
Rated
value
A
B
C
Mode
Descriptions
MS-(H)-Pro Digital(Hotplate)Magnetic Stirrer
Note:
If both heating and stirring functions have been
started at the same time, the display of function
"heating" always has higher priority. If in this
case speed is changed via the stirring knob, it
display stirring speed and reverses to temperature
in the duration of 5 seconds.
6 Initialization
6.1 Initializing sequence
• Turn on instrument by the power switch.
•
The "Heat" and "Stir" LEDs and the LCD display
flash about 3 times.
•
LCD displays the workplate
"SAFE xxx°C".
• LCD displays residual heat warning "rES On/OFF".
• LCD displays stirring bar breakaway monitoring "br On/
OFF".
• LCD displays operating modes(A、B、C).
•
LCD displays the "Probe" characters in case of
connecting with external temperature sensors.
6.2 Default settings
MS-(H)-Pro is supplied with the following default settings
7
,
s safe temperature limit in
Need help?
Do you have a question about the MS-H-Pro and is the answer not in the manual?