Display (Hotplate Model); Trial Run - Scilogex SCI7-S User Manual

Hotplate/stirrers
Table of Contents

Advertisement

When
LED Stir
switched ON, the LED Stir is
lit.
Switch
Power Switch
instrument.
Table 2

4.2 Display (Hotplate Model)

Figure 6
Display
When the heating function is switched ON and
rotate the stirring knob, LED displays the
temperature setting value and shifts to real value
Display
in 5 seconds.
area
When the heating function is switched OFF and
the hotplate temperature is still above 50℃,
LED displays Hot, otherwise LED displays 0.
the
instrument
ON
or
OFF
Display area
Descriptions
is

5. Trial run

• Make sure the required operating voltage and power
supply voltage match.
the
• Ensure the socket must be properly grounded.
• Plug in the power cable,ensure the power is on and begin
initializing.
• Add the medium into the vessel with an appropriate
stirring bar.
• Place vessel on the work plate.
• Clockwise rotate the stirring knob slowly to set the rated
rotary speed in the safe speed range from 0 to 1500rpm, and
start stirring function.
• Clockwise rotate the heating knob slowly to set the rated
temperature in the safe range from room temperature to
550℃, and start heating function (hotplate model).
• Begin the heating and stirring functions.
If these operations above are normal, the device is ready to
operate. If these operations are not normal, the device may
be damaged during transportation, please contact
manufacturer/supplier for technical support.
6
LED Digital 7" Square Hotplate Stirrer

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCI7-S and is the answer not in the manual?

This manual is also suitable for:

Sci550-s

Table of Contents