Carrier 42QHP09E8S Service Manual page 51

Procedure
3) Remove the hex nuts and washers securing
the compressor, located on the bottom
plate (see CJ_ODU_INV_010 ).
4) Heat up the brazed parts and then remove
the the discharge pipe and the suction
pipe (see CJ_ODU_INV_011 ).
5) Lift the compressor from the base pan
assembly with pliers.
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
CJ_ODU_INV_010
Discharge Pipe
CJ_ODU_INV_011
Suction Pipe
 Page 47 