Carrier 42QHP09E8S Service Manual page 36

Procedure
5) Disconnect the wires. Then remove the
electronic main box (CJ_OP_INV_011-
2).
6) Pull out the Electrical control box along
the direction indicated in right image.
to remove it (CJ_OP_INV_011-2).
7) The connector of each port is indicated
in right image. (CJ_OP_INV_013).
Note: This section is for reference only. Actual unit appearance may vary.
 Page 32 
Illustration
CJ_OP_INV_012
Pipe Temperature Sensor
Display Board Swing Motor
CJ_OP_INV_013
Main Board
Electronic Box
Terminals
Ground Wire
Indoor Fan Motor