Carrier 42QHP09E8S Service Manual page 35

2. Electrical parts
Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.
Procedure
1) Cut the ribbon by a shear, then pull
out the coil temperature sensor (T2)
(see CJ_OP_INV_010).
2) Remove the two screws used for
the ground connection (see CJ_OP_
INV_010).
3) Remove the fixing screws(1 for
electronic cover and 1 for terminal
cover), and then remove the cover of
electronic box and the terminal cover
along the direction indicated in right
image to remove it.
4) Disconnect the connector of fan
motor and the step motor (see CJ_OP_
INV_011).
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Ground Screws
Ribbon
CJ_OP_INV_010
CJ_OP_INV_011
T2 Sensor
 Page 31 