Carrier 42QHP09E8S Service Manual page 37

3. Evaporator
Note: Remove the front panel and electrical parts (refer to 1. Front panel and 2. Electrical parts) before
disassembling evaporator.
Procedure
1) Disassemble the pipe holder located at the
rear of the unit (see CJ_OP_INV_014).
2) Remove the 3 screws on the evaporator
located at the fixed plate (see CJ_OP_
INV_015).
3) Remove the 2 screws on the evaporator
located at the base of the bearing side (see
CJ_OP_INV_016).
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
CJ_OP_INV_014
Screws
CJ_OP_INV_015
Screws
CJ_OP_INV_016
Pipe Holder
 Page 33 