Advertisement
Parameterisation table for further settings of the modules
3. Software activation on the myGEKKO
After connecting the Beckhoff modules you can start with the configuration.
Log in as configurator.
1.
Change to the system menu -> IO configuration
2.
Select the first free IO station and set Modbus. (The address of the coupler and the number of
the IO station must match)
3.
Select the interface.
4.
The baud rate must be 38400.
5.
Reg In Start is 0, Reg Out Start is 2048
6.
Save under Reg In Digital or Reg Out Digital the digital inputs or outputs and under Reg In
Analogue or Reg Out Analogue the analogue inputs or outputs
7.
Reg Order must be selected Analogue+Digital
7
Advertisement
