Chapter 2: Device Controls And Displays; Controls And Displays - Respironics REMstar Pro M Series User Manual

C 2: D
HAPTER
This chapter describes the device's control buttons and displays, patient circuit connections, and
rear panel connections.
2.1 C
ONTROLS AND
Figure 2–1 shows the three primary control buttons on the REMstar Pro M Series device.
These buttons are described below.
If you do not want to modify the settings that your home care provider has set for you, you only
need these three buttons to start and stop therapy and do not need to use the display buttons lo-
cated under the device cover door.
Figure 2–2 shows the device display and navigation buttons that are under the cover door.
REM P M S
STAR RO ERIES
C
EVICE ONTROLS AND
D
ISPLAYS
F
IGURE
B
UTTON
Ramp – When the airflow is on, this button allows you to
activate or restart the ramp function. Ramp lowers the
airflow pressure and then gradually increases it, allowing
you to fall asleep more easily.
Start/Stop – This button starts the device's airflow and
places the device in the Active state, or stops the airflow,
and places the device in Standby. You can also press this
button to exit any setting screen.
C-Flex
C-Flex – This button adjusts the C-Flex comfort setting.
F
U M
SER ANUAL
D
ISPLAYS
2–1 P C
RIMARY ONTROL
D
– FOSQ Setup
2–2 D B
IGURE ISPLAY UTTONS
C-Flex
B
UTTONS
ESCRIPTION
+
2-1