Respironics REMstar Pro M Series User Manual page 39

The Patient Setup screens are described below.
– FOSQ
Setup
C-Flex Setting
1 2 3
C-Flex Setting
FLEX comfort has been
disabled on this unit.
Ramp Start Pres
4.0 cmH 2 O
Mask Alert
Feature: ON
REM P M S
STAR RO ERIES
1. Standby Screen
The Standby screen appears when you first apply power to the
device. You can access the Patient Setup menu from this screen by
+
pressing the + button. Once inside the Setup menu, press the
or buttons to cycle through the screens.
2. C-Flex Setting Screen
This screen displays the C-Flex level set by your home care
provider. This setting allows you to adjust the level of air pressure
relief that you feel when you exhale during therapy. Your home
care provider will either enable or disable C-Flex.
– If C-Flex is enabled and the setting is not comfortable for you,
you can increase or decrease the setting by pressing the + or
– buttons. The setting of 1 provides a small amount of pres-
sure relief, with higher numbers providing additional relief.
Press the + or – buttons to increase or decrease the setting.
– If your provider has disabled C-Flex, you cannot enable or ad-
just the setting. The screen shown at left displays to indicate
that C-Flex is disabled.
3. Ramp Starting Pressure Screen
You can increase or decrease the ramp starting pressure in 0.5 cm
H O increments by pressing the + or – buttons. The default setting
2
is 4 cm H
pressure setting.
Note:
4. Mask Alert Screen
You can enable or disable the mask alert setting by pressing the +
or – buttons to select OFF or ON. If this feature is enabled, then the
words Mask Leak appear on the Active display screen if a signifi-
cant mask leak is detected, and an audible alert sounds.
Note:
U M
SER ANUAL
O. You can adjust the setting from 4 cm H
2
This screen will not display if your provider has not en-
abled Ramp on your device.
If your physician indicates that the Mask Alert is neces-
sary for you, do not disable it.
O to the CPAP
2
4-9