Technical Specifications - E.T. Systems Drive 500 User Instructions

5. It is highly recommended that a set of safety infra-red beams be used in conjunction with this product. The safety beams must be
installed in such a way that the product is prevented from running when anything is in the path of the door or gate.
6. Over and above the recommendation to use safety infra-red beams with this product it is mandatory to install and use a safety
beam set when using the automatic closing feature. It is recommended that a warning light be fitted to any automation system.
7. The emergency manual release instruction label must be installed on or adjacent to the emergency manual release mechanism.
After installation - It is the responsibility of the installer to ensure the users:
1. Is proficient in the use of the manual emergency release mechanism.
2. Is issued with the documentation accompanying this product.
3. Understands that the gate or door may not be operated out of clear sight.
4. Ensures that children are kept clear of the gate or door area at all times, and that children do not play with the remote transmitters
or any fixed trigger switches linked to the system.
5. Is instructed not to attempt to repair or adjust the automation system and to be aware of the danger of continuing to use the
automation system in an unsafe condition before a service provider attends to it.
6. Is proficient in testing the unit's safety obstruction sensing system.
7. Is aware of what to check for with regards to wear and tear that may need to be attended to from time to time by the service
provider.
8. Is aware that a fatigued battery may not be disposed of in the general refuse and must be handed in at a battery merchant for safe
disposal. Before removing the battery from the system the household mains must be disconnected. In the case of the motor unit
being removed and scrapped, the battery must be removed first.
Technical Data
Rated gate mass.
Maximum gate travel.
Primary power supply to gate.
Peak power consumption at gate.
Electrical class.
Motor voltage.
Motor current.
Duty cycle maximum.
See determining your duty cycle on page 7.
Number of operations on battery reserve.
(Battery health and charge level at time of
power failure dependent. Calculated on a 5m
gate with rolling resistance of <10kgf)
Gate speed.
(Gate load and power supply dependent)
Rated Load.
Operating temperature range.
Anti-crushing safety sensing.
Auxiliary supply output.
Built in battery charger.
Receiver format.
Receiver frequency.
Receiver channels.
Receiver memory capacity.
All users can be allowed control of all channels.
Ingress protection
Physical dimensions

Technical specifications.

TECHNICAL SPECIFICATIONS
Drive 500
500kg
99m
16Vac @ 1A 50Hz – 60Hz
26W
Class 3
12Vdc
Current limited to 25A.
25% with 220Vac present
100 using the standard 7Ah battery within
24hrs.
Up to 28m/min.
300N
-10 to 50° C (14F to 122F)
Yes – Electronic gate profiling
12Vdc @ 500mA
Multiple stage auto-calibrating 1A
ET BLU MIX © backward compatible with ET
BLUE (Rolling code)
433.92MHz
4CH (BT, PED, Aux relay, Holiday lock-out)
1023 users
Yes
IPX4
See next page.
4
Drive 600
500kg
99m
220 – 240Vac @ 50Hz – 60Hz
240W
Class 1
12Vdc
Current limited to 25A.
98% with 220Vac present
100 using the standard 7Ah battery within
24hrs.
Up to 30m/min.
300N
-10 to 50° C (14F to 122F)
Yes – Electronic gate profiling
12Vdc @ 500mA
Multiple stage auto-calibrating 1A
ET BLU MIX © backward compatible with ET
BLUE (Rolling code)
433.92MHz
4CH (BT, PED, Aux relay, Holiday lock-out)
1023 users
Yes
IPX4
See next page.