Condominium Auto-Close Mode - E.T. Systems Drive 500 User Instructions

Basic operating
features
The BT functions are the primary full gate opening functions for motor vehicle access.
There are two ways of activating the "BT" functions on this control card. Either via the hardwired BT input or the BT receiver channel.
In Condominium auto-close mode, all BT triggers are treated as open, keep opening, keep open or re-open triggers. The gates will only close once the
BT auto-close timer has timed out.
In Condominium auto-close mode the following advanced features are NOT available: - Holiday lock-out and Party mode.
NB! For any auto-close feature to work, a pair of safety infra-red beams must be installed and functioning correctly. If no safety infra-red beams are
installed then the gates will open but not close again.
Action
Momentary BT trigger.
Momentary BT trigger
while gate is opening.
At full open position.
Momentary BT trigger.
Auto-close timer
timeout. Safety beam
input not triggered.
Momentary BT trigger.
At full open position.
Auto-close timer
timeout. Safety beam
input not triggered.
At full closed position.
Gate closed.
0
0 sec.c.
0
0 sec.c.
"BT" Button triggers.

Condominium auto-close mode.

Gate begins
No buzzer tones.
opening.
The trigger is
ignored and the
No buzzer tone.
gate continues
opening.
Gate stops
and auto-close
No buzzer tones.
timer starts
counting down.
Gate remains
open and auto-
No buzzer tones.
close timer
resets.
Gate begins
No buzzer tones.
closing.
Gate stops and
immediately
No buzzer tones.
starts opening
again.
Gate stops
and auto-close
No buzzer tones.
timer starts
counting down.
Gate begins
No buzzer tones.
closing.
Gate stops. No buzzer tones.
10
Response
0
20 sec.
0
20 sec.
0
20 sec.