Installing The Assemblies - Air Lift LoadLifter 5000 Ultimate Installation Manual

LoadLifter 5000 Ultimate

INSTALLING THE ASSEMBLIES

1 . Set the left and right hand assemblies onto the axle . Make sure the brake line that
2 . Cap the upper bracket's 3/8"-16 X 1 .5" carriage bolts (J) with a 3/8" flat washer
3 . Insert the last two 3/8"-16 X 7" carriage bolts (K) into the last holes in the lower
MN-970
was un-bolted on the left (driver) side is clear while positioning the assembly . Raise
the axle or lower the frame so that the upper bracket carriage bolts go through the
existing jounce bumper holes in the bottom of the frame . Also, make sure that the
flanges on the upper bracket fit on the inside of the lower frame flange (Figs . 18 & 19) .
The fitting is
facing toward
the outside
of the vehicle
frame .
Make sure
brake line is
clear when
positioning
assembly into
position on
driver side .
(I) and 3/8"-16 nylon lock nut (L) . Push the flange of the upper bracket outboard
(against the frame) as far as it will go and torque the upper mounting hardware to
15 lb .-ft . (Fig . 19) . Repeat for the opposite side .
Vehicle frame
bracket behind the axle . Make sure the passenger side goes on the outside of the
hard brake line as shown in Figure 20 .
L
K
Left (Driver)
side shown
Make sure the
flange on the
upper bracket is
on the inside of
the lower frame
flange as shown .
fig. 18
I
Upper bracket
fig. 19
Right (Passenger)
side shown
fig. 20
11