Installing The Assemblies - Air Lift LoadLifter 5000 Ultimate Installation Manual

LoadLifter 5000 Ultimate

INSTALLING THE ASSEMBLIES

1 . Index a 3/8" carriage bolt (L) into the opening on the front of the driver side assembly
2 . Drop the axle again to gain clearance to put the two assemblies into position on the axle .
3 . Set the driver side assembly into position with the carriage bolt still in the slot (previously
MN-944
Left side
assembly
(driver side)
using Lower
Bracket (C1) .
as shown (fig. 21).
installed) . Set into place on the axle making sure the back of the bracket is "hooked"
below the jounce bumper strike plate . Push the assembly forward while lining up the
carriage bolt with the existing hole in the front of the lower jounce bumper strike plate
(figs. 22 and 23). Cap the carriage bolt with a 3/8" serrated lock nut (N), but leave loose
at this time .
Right- side
assembly
(passenger
side) using
lower bracket
(C2) .
fig. 20
L
fig. 21
fig. 22
11