LoadLifter 5000 Ultimate
Installing the LoadLifter 5000 Ultimate System
GETTING STARTED
COMPRESSED AIR CAN CAUSE INJURY AND DAMAGE TO THE VEHICLE AND PARTS
DANGER
IF IT IS NOT HANDLED PROPERLY . FOR YOUR SAFETY, DO NOT TRY TO INFLATE THE
AIR SPRINGS UNTIL THEY HAVE BEEN PROPERLY SECURED TO THE VEHICLE .
1 . Raise the vehicle and support it in some way, using jack stands or equivalent, so
2 . In order to install the kit, it will be necessary to remove the stock jounce bumpers and
3 . It will be necessary to temporarily remove the vent/brake line junction block on the
MN-970
that the axle can be dropped safely away from the frame . This will need to be done
in order for the air spring assembly to be put into position between the axle and
frame (Fig . 2) . Figure 2 shows the frame being supported with the vehicle on a drive
on hoist .
mounting brackets from under the frame rails on both sides of the vehicle (Fig . 3) .
driver side from the axle bracket (Fig . 4) . Do this by pulling the clip off the front side
of the junction block and pull it back to remove it from the bracket .
fig. 2
Stock jounce
bumper
Mounting
bracket
fig. 3
fig. 4
5