LoadLifter 5000 Series
D. Installing the LoadLifter 5000 Series System
GETTING STARTED
1. Raise and support the vehicle in a way, using safety stands or equivalent, that the
2. Remove the factory bolts that hold the upper brake line bracket in place. Reattach
3. Locate the jounce bumpers. Using a 10mm deep socket, remove the jounce bumpers
MN-1085
axle can be safely dropped away from the frame. This will need to be done for the air
spring assembly to be put into position between the axles and frame (Fig. D.1).
the bracket using the two new M8-1.25 x 50 hex head cap screws (K), two new M8
flat washers (L), and two new spacers (H) (Figs. D.2 & D.3). Torque bolts to 10 lb.-ft.
(14Nm).
Factory
bolts
fig. D.2
(both sides) and discard (Figs. D.4 & D.5).
Jounce
bumper
fig. D.4
fig. D.1
K
L
H
fig. D.3
Jounce bumper removed
fig. D.5
5