Assembling The Air Spring Assemblies - Air Lift LoadLifter 5000 Ultimate Installation Manual

LoadLifter 5000 Ultimate

ASSEMBLING THE AIR SPRING ASSEMBLIES

1 . Set a roll plate (E) on top of the air spring (D) . The radiused or rounded edge of the
2 . Insert the 3/8"-16 X 1 .5" carriage bolts (J) through both upper brackets (C) as shown
3 . Set the brackets on both air spring assemblies and attach with 3/8-16 X 7/8" hex
MN-970
roll plate will be towards the air spring so that it is seated inside the roll plate (Fig . 8) .
Install the 90° swivel fitting (F) into the top of the air spring, finger tight plus one and
a half turns .
(Fig . 9) .
cap screws (G), 3/8" lock washers (H) and 3/8" flat washers (I) . Leave loose at this
time (Fig . 10) . Figure 11 shows the upper air spring assembly .
G
H
I
fig. 10
F
E
D
J
C
fig. 11
fig. 8
fig. 9
7